Flying Bear P902 3D printer tramming, construct ideas, and potential points

How I squared the machine up, and trammed the axes.

I forgot to say that every one Z axis blocks have been centered on the extrusion from entrance to again (within the Y axis), and you need to tighten the Y rail mounting blocks with the Y carriage as near the blocks as attainable similar to I did on the Z. Additionally, loosen one of many Y transmission pulleys whilst you alter, and tighten when accomplished to endure your belts do not struggle one another and pull X axis out of sq..

Be a part of the FB goup on FB when you havnt:

Latest Comments

  1. Alfredo Antonio Martinez June 19, 2017
  2. David Koper June 19, 2017
  3. Nico June 19, 2017
  4. gant gantushig June 19, 2017
  5. hasso0n June 19, 2017
  6. Pike Minnow June 19, 2017