3D Printed Seahawks AR-15 Rifle Construct



My second try at a 3d printed AR-15 decrease receiver. This one known as the JT Vanguard and is a really good mannequin.
It’s a part of the FOSSCAD package deal. I made a decision to embellish this one in my very own customized Seattle Seahawks theme to make it extra fascinating.

Skip to 11:23 if you happen to do not wish to watch me set up the decrease receiver components.

This was printed in ABS with .2mm layers on my Ultimaker 2.
It makes use of $Eight-10 price of filament, and sadly it took me three tries to get a superb print. It additionally takes 24-48 hours to print relying in your settings. I am certain I may get extra good prints with out so many failures now that I’ve found out the method a bit higher. Helps are essential for this print since a lot of the half sits on helps.

THIS PROJECT IS NEITHER ENDORSED NOR SPONSORED BY THE SEATTLE SEAHAWKS OR THE NFL. I am only a fan! That is NOT on the market and NO I cannot make you one. 🙂 That is for my very own private non-commercial use.

GO HAWKS!

Latest Comments

  1. andrew lozano November 14, 2017
  2. Rodnei Aguiar November 14, 2017
  3. Jerreinemy November 14, 2017
  4. ii_FuRy November 14, 2017
  5. Christopher Sexton November 14, 2017
  6. Rhino3D 3DRender November 14, 2017
  7. Jester Blackguarde November 14, 2017
  8. Kevin Storm November 14, 2017
  9. Kevin Storm November 14, 2017
  10. 皈依成佛 November 14, 2017
  11. jakob qasadilla November 14, 2017
  12. Manolo Ruiz Mendez November 14, 2017
  13. Joji Donald November 14, 2017
  14. Khrissy Beats November 14, 2017
  15. Yodaboyot Boyotjedi November 14, 2017
  16. Jordan Torres November 14, 2017
  17. david whipple November 14, 2017
  18. dourabbawinner November 14, 2017
  19. subydude November 14, 2017
  20. Nathan Dean November 14, 2017
  21. Nathan Dean November 14, 2017
  22. Adam Long November 14, 2017
  23. Wayne Neary November 14, 2017
  24. crazywhitedog78 November 14, 2017